HANDRAIL
ALUMINIUM HANDRAIL
Industrial Aluminium Handrail is 1100mm High with an intermediate horizontal rail 550mm above the walking surface. The system uses 6082-T6 Aluminium Tube and TUV approved Slip-On fittings.
The main advantage of this system is there is, no requirement of any welding, drilling or bolting. All slip-on components are high-grade aluminium (A356-T6) and Anodised AA20-AA25 Finish.
All slip-on components bear a specific model number for easy identification & installation at site. Aluminium tubing shall be of high-grade 6082-T6 marine grade aluminium, Anodised AA20 – AA25 Finish. Tube size 48.5mm O/D x 3.25mm thick (min) for Top and Mid Rails.
Uprights of 48.5mm O/D x 4.00mm or 48.5mm O/D x 7.80mm wall thickness respectively. A hexagonal key is used to tighten the set screw of the slip-on components on to the tubing.
The system is designed as to support an axial load of 770kg per set screw, with the set screw tightened to a torque of 39Nm rating and have a safety factor of 2:1. Toeboards are150mm high extruded profile and extruded from 6082-T6 and anodised AA20 – AA25 Finish.
The specific extrusion profile of the board will help limit warping in excessive heat. The toeboards are fixed directly to an upright post, by using a “U” clamp around the upright fitted and bolted to a slot on the rear face of
the toeboard.
TECHNICAL SPECIFICATION
PICTURES
GMS HANDRAIL
Industrial GMS Handrail is 1100mm High with an intermediate horizontal rail 550mm above the walking surface.
Industrial GMS Handrail is designed, using Steel ERW Tube and Slip-On components. The main advantage of this system is there is, no requirement of any welding, drilling or bolting.
All slip-on components are Iron castings, to BS EN 1562 and BS EN 1563 and are hot dip galvanized finish. All slipon components bear a specific model number for easy identification & installation at site.
The slip-on fittings have been rigorously Tested and Approved by TUV.
The tube size is 48.3mm O/D with wall thickness of 3.8mm min to 5.0mm max. (Top, Mid Rails & Stanchions) A hexagonal key is used to tighten the set screw of the slip-on components on to the tubing.
The system is designed as to support an axial load of 770kg per set screw, with the set screw tightened to a torque of 39Nm rating and have a safety factor of 2:1.
The toeboards are of 150mm high extruded profile and will be of high-grade 6082-T6 and anodised AA20- AA25 Finish.
The specific extrusion profile of theboard will help limit warping in excessive heat.
The toeboard can be fixed directly to an upright post, by using a “U” clamp around the upright fitted and bolted to a slot on the rear face of the toeboard.
The toe board has a maximum ground clearance of 10mm, to ensure that any potential water and dust does not build up.
TECHNICAL SPECIFICATION
PICTURES
